Breedlove Quartz KF - the peg

  1. iancohen82
    iancohen82
    The peg on the bottom of my mandolin where I'd attach the strap isn't tight and can easily come out. Any suggestions as to what I should do? Thanks!
  2. multidon
    multidon
    Depends on what type of end pin you have installed. My Quartz FF was drilled for an end pin jack but does not have one so it was fitted with a rubber compression nut. I suspect many of these are installed at the factory because it is cheaper for them to drill end pin holes all the same way. Just tightening the screw should solve that. If yours has a regular type of friction fit pin try putting a small piece of masking tape on the shaft as a shim. This should tighten it up.

    Don
Results 1 to 2 of 2