Here’s a solution for mounting an Audio-Technica Pro 35 mic that I hadn’t seen before, so I thought I’d share it. Apologies if it’s been done before (and I’m sure it has).
I’ve seen folks simply clip the Pro 35’s alligator clip to a DPA violin mount, but that seemed sort of flimsy and unstable. I noticed that the clip appeared to be attached to the gooseneck by a small screw, so I removed the screw and - viola - the alligator clip slid right off. I then simply zip-tied the gooseneck into the existing slot on the DPA mount. This set-up stays in place much better than just using the clip, and is less obtrusive than using a zip-tie with the clip still attached to the gooseneck.
Hope you all find this useful!
Bookmarks