Results 1 to 4 of 4

Thread: Old Gibson A case catch straps

  1. #1
    Registered User J.C. Bryant's Avatar
    Join Date
    Nov 2002
    Location
    Poplar Bluff, Missouri
    Posts
    309

    Default Old Gibson A case catch straps

    I have an old gibson case and both the "catch straps" ( the cloth thngs that keep the top from falling completely open) are gone. Have any of you fixed this and how would you recomend I proceed? thanks

  2. #2
    Moderator MikeEdgerton's Avatar
    Join Date
    Mar 2007
    Location
    Howell, NJ
    Posts
    24,954

    Default Re: Old Gibson A case catch straps

    Cafe member Loudloar (Steve Kirtley) has a website and a Facebook group dedicated to vintage cases. There is a page on his website that has some suggestions about repairing old cases. It's here.
    "Bargain instruments are no bargains if you can't play them". These are the words of J. Garber.

  3. The following members say thank you to MikeEdgerton for this post:


  4. #3
    Registered User
    Join Date
    Aug 2011
    Location
    Corinth, VT
    Posts
    115

    Default Re: Old Gibson A case catch straps

    I have replaced the case 'ribbons'(for want of a better term) on numerous vintage cases, including Gibson mando cases. Steve Kirtley's site and FB page have been invaluable to me, in learning about case repair.
    I buy rolls of ribbon material, in different colors, from the Joanne's Fabrics chain. Basically, one must peel away the cloth or plush lining(I use a very small flatbar tool), remove the vestiges(including tacks) of the original ribbons, and then cut new pieces of correct length: I use a hot-melt glue gun(careful! very hot!) to secure first one end, and then the other, of the new ribbon(s) to the case side. That part is slightly tricky, as they want to be just long enough to hold the lid open at a good angle...but not too short, nor too long. I then reglue the lining to the case side, also with HMG.
    Best of luck!

  5. The following members say thank you to Dave Richard for this post:


  6. #4
    Registered User tree's Avatar
    Join Date
    Mar 2005
    Location
    northern Virginia
    Posts
    1,502

    Default Re: Old Gibson A case catch straps

    I replaced the green ribbon in the case for my old A2 in very much the same manner as Dave describes above, except I reused the tacks to hold the ends of the ribbon in place and used a different glue (epoxy, I think). With luck it'll be another hundred years before anybody needs to repair them again and curses whoever used the wrong glue . . .
    Clark Beavans

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •